Customer Reviews for VEVOR Transmission Fluid Pump, 3 L Capacity, Manual Fluid Transfer Pump with 120 cm Long Horse & HDPE Tank, Transmission Oil Pump with PTFE Tape, Manual Automotive Oil Filling System

It works great for extracting oil from engines. The manual pump works like a charm. It makes boat changes easy.

It works great for extracting oil from engines. The manual pump works like a charm. It makes boat changes easy.

needed this to drain my lawnmower oil. really did a great job. it takes about 10 pulls to get all the oil out, and the suction is strong so it takes some strength to do each pull, but the extension on it enables you to get all the old oil out which is key.

The pump worked well for transferring fluid once I fixed a permanent kink in the hose where it exited the bottle. It really could use a 90 degree fitting here because the funnel-shaped black flange interferes with the hose, and causes the kink. Also, DO NOT rely on the fluid level markings (liters) on the side of the bottle, because they aren’t even close. See photo. Instructions mention a quick coupling, which was not included, but I suspect it was on an earlier version.

Seth gut empfehlen weiter zum kaufen

This transfer pump is a nice item to have when whatever you are filling is either in a hard to reach spot or you don't have the head room for use a funnel. Transmissions, rear axels and even recessed fill ports on some riding lawn mowers. This can get a good amount of pressure built up to push most of the fluid that you put in it. Need to make sure where in the bottom your hose is setting so you can make sure it is as submerged as possible to get all that you can out. You can adjust the flow by pumping the handle slowly or adjusting the valve. I would rely on pumping for a bit better fluid control. The ball valve is fine for the application but it only has full off in 2 directions before you hit any stops. So if you are not looking at the ball valve then you can go past the full open position and start closing it off again. It is easy to turn but you still might need to hold the hose when opening or closing the valve. The hose and bend and stay tube gives you enough length for most tight spots but if you need longer, the ball valve is a female thread that is pretty standard so you should be able to extend this with whatever you need to, even hard line if one wanted. The strap is nice but can be a little bit of a pain to hook in because of the key ring style rings they give. The main problem that I have with this is the capacity measurement is off. I put in 2 bottles of 1 quart oil into this which is almost 1 litter each but the reading for both came up to 1 litter over all. So don't go by the marking lines of exactly how much is in there because you will be atleast 1 litter over. You can still use the marking lines as they are properly spaced. I would say over all this is worth it if you need something like this. It will do the job of transferring oil into whatever you are putting it in.

Still needed small holes because attachment are to small in diameter and hard plastic should have rubber ends like brake attachment

Works as expected. Vevor includes attachments that I have no clue how, when or where I would ever use them. The instructions for the attachments and when, how to use are very poor. It gives you the illusion of getting a lot for your money.

Handy extractor for a variety of uses. The larger size is great for changing oil/fluids in lawnmowers, generators, automotive and more. Only downside is over time the rings can become stiff and it becomes hard to move the piston. The more often you use it, the better it works. Silicon spray can help if it gets stuck.

works well however the measurements on the side are not correct. 0.5L is actually 1.0L aside from that it worked a treat. Picture shows 1L litre of oil in the pump. if you know it’s ok but trying to work out how much oil you put in is a bit tricky😂