Customer Reviews for VEVOR Track Saw Guide Rail, 1397 mm Cutting Range, Kit Includes 2 x 698.5 mm Aluminum Extruded Guide Rails and 1 Connector, Compatible with Makita, Festool & WEN Track Saws, for Woodworking Projects

produit pas terrible le caoutchouc de contact s'est décollé très rapidement.

Poor quality, not square, rubber edge all twisted and falling off. Would not recomend.

I’ve only had the tracks for a couple of weeks. Very dissatisfied with the quality. The rubber pads on the back of all of them have come loose. I would not recommend them.

les connecteurs ne sont tout à fait à dimension du rail alu, donc il y a du jeu. Une fois les connecteurs montés et serrés, difficile d'avoir un linéaire parfait. Dommage, c'est quand ce que l'on demande pour un guidage.

Bad product out of the box with rubber strip falling apart. Brand new useless product.

I got it because it said it was going to be compatible with Makita and festool , it’s not the track too big and the track saw doesn’t fit

Ne glisse absolument pas avec une scie Makita. Il faut forcer comme un malade pour que la scie avance et attacher le guide.

Nothing wrong with the track, but it doesn't fit the Wen track saw.

The trackswere straight, and lined up when assembled. However, the rubber edge and plastic glide strips were coming loose, and had to be reattached. There wasn't any physical damage to the packaging, so I suspect poor quality control. The cost was low and I needed a short track to perform a task, so it was worth buying and fixing.

The "low-friction glide strips" have started to peel away from the track which isn't good and the grub screws for the joiner actually deformed the aluminum on the top side with minimal torque. I applied only enough torque to keep the halves from separating and that resulted in four small bumps on the top side which do not cause a lot of issues but it does cause the saw to lift slightly while passing over the bumps which means the cut isn't perfect. The price was right though. I just wish it were a single 55 inch piece instead of two 27.5 inch sections then the joint wouldn't be needed.