Customer Reviews for VEVOR Fluid Extractor, 9.5 L Capacity, Manual Vacuum Fluid Extractor with 150 cm Long Horse and Three 120 cm Extension Tubes, Oil Change Pump with HDPE Tank for Cars, Lawn Mowers, Boats

This transfer pump is a nice item to have when whatever you are filling is either in a hard to reach spot or you don't have the head room for use a funnel. Transmissions, rear axels and even recessed fill ports on some riding lawn mowers. This can get a good amount of pressure built up to push most of the fluid that you put in it. Need to make sure where in the bottom your hose is setting so you can make sure it is as submerged as possible to get all that you can out. You can adjust the flow by pumping the handle slowly or adjusting the valve. I would rely on pumping for a bit better fluid control. The ball valve is fine for the application but it only has full off in 2 directions before you hit any stops. So if you are not looking at the ball valve then you can go past the full open position and start closing it off again. It is easy to turn but you still might need to hold the hose when opening or closing the valve. The hose and bend and stay tube gives you enough length for most tight spots but if you need longer, the ball valve is a female thread that is pretty standard so you should be able to extend this with whatever you need to, even hard line if one wanted. The strap is nice but can be a little bit of a pain to hook in because of the key ring style rings they give. The main problem that I have with this is the capacity measurement is off. I put in 2 bottles of 1 quart oil into this which is almost 1 litter each but the reading for both came up to 1 litter over all. So don't go by the marking lines of exactly how much is in there because you will be atleast 1 litter over. You can still use the marking lines as they are properly spaced. I would say over all this is worth it if you need something like this. It will do the job of transferring oil into whatever you are putting it in.

works well however the measurements on the side are not correct. 0.5L is actually 1.0L aside from that it worked a treat. Picture shows 1L litre of oil in the pump. if you know it’s ok but trying to work out how much oil you put in is a bit tricky😂

It looks good however fluid leaks

Hard to draw up small engine oil, I should have bought the bigger one

Very hard to pull the handle, not sure why. I lubricated the two O rings with WD40, Vaseline and slip it, none of them helped. In the trash it went.

Was planning on using this to service transmissions but it came in broken so definitely wouldn’t recommend there must not be any quality control

Do not recommend , extremely hard to suck or extract oil . Doesn’t work nowhere near as good as what I expected. Not worth the money

nu recomand

I actually kind of like this but Vevor just canceled my order and account for having returned a few items and used the highly offensive fraud adjacent language to do so. I advise against buying anything by Vevor given the sketchy return policies.

Never got my order’ delivered. I got a lot of orders from them but I’m disappointed I done with them. I can’t get a answer from them and a refund.