Customer Reviews for VEVOR Electric Concrete Saw, 14" Concrete Cutter, 1800W Concrete Saw, Electric Circular Saw with 14" Blade and Tools, Masonry Saw for Granite, Brick, Porcelain, Reinforced Concrete and Other Materials

Did exactly what I needed it to do. Cuts concrete blocks very well. I was using as a wet saw. I need to try to find a way to connect directly to a hose rather than using the pump and a bucket.

Works great, just take your time cutting and don’t do long cuts or it might overload your circuit. I didn’t have a 20 amp circuit to plug it into so that would have helped. I got an adaptor cord that plugs into my oven outlet and runs much better on that.

good tool for the price ...buy it for the cost of 1 day rental. Water feature is a plus..thats all I am going to write about it.................................................................................................................................................................................................................................................................................................================================================================================================================================================================================================================================

The saw works well. Please remember this is an electric saw. It is much slower than gas powered but no fumes indoor. Also I wish it was made in 240V as opposed to 120v. The saw requires a 30 amp circuit and 10/3 wire to the saw to work properly. A 30a-120v RV outlet would be perfect. You must adapt to the 15a-120v plug on the saw to a 30a plug. Overall price/value is impressive. Thanks L Smith

Very good saw, so far we are very happy. .

Over all Its a nice unit to have for the price. We were inside a store and dust and gas fumes were not an option. The pump and water helped this condition a lot. The job was - We had to make about 80 feet of cuts through 5" concrete with wire to replace a bad waste line. It did the job the only big complaint is that it will pop your 20 Amp breaker often. So what I did was installed a 30 amp breaker on the panel and made a custom 10/3 cord. We can use this set up any time we run the saw. Best not to try and go more than a 25 to 50 foot cord as there will be a heavy draw on the saw. If you go with there smaller units maybe the breaker pop issue is not a factor? Im on my 3 Vevor tool and so far so good. Way better than Harbor Freight stuff.

The saw worked great. Not quite as powerfull as I was hopping but worked fine. After a couple of days, the trigger lock started getting stuck a bit. But otherwise works well.

The saw is great to work with and so far no issues with it. The included pump can overheat so turn it off when not using the saw or the valve is closed. If you are cutting pavers greater than 3.5 inches you will need to flip it but it still cut straight and clean. Overall it is great.

I have received it

Water valve showed up broken, didn't know until I went to use it(4 days later) and now I have to wait for somebody to decide if I will be getting a warranty part? Seems pretty silly