Customer Reviews for VEVOR Pressure Washer Pump, 3/4" Shaft Horizontal Triplex Plunger, 3300 PSI, 2.5GPM, Replacement Power Washer Pumps Kit with 5 Nozzles, Compatible with Simpson MorFlex 40224, 40225, 40226, Santoprene

It was really easy to install and works just fine Will see how long it lasts

Ottima e molto potente

Plugged right in and works as well as the original.

I've been.pleasntly surprised by how well the pressure pump worked.

Adorei o produto. É muito bom

I used this to replace the faulty pump on my Husqvarna pressure washer. I actually mounted it upside down and it works great.

Refreshed my well used PW to like new at a fraction of replacement.

works great

Just as described

Bolts right up and pumps fine. I wish they'd use hex head bolts vs socket screws. There's no way to get a dead-on allen key in there so you're left with either cutting a right angle hex key down or making a ball hex make it "good enough." The oil vent cap didn't screw properly and was a tight despite not fully threading down. This allowed water to get into the oil (milky/cloudy appearance). Thankfully, the sight glass is easy to check and I went ahead and changed the oil - I used SAE 30 Non-detergent - it takes approx 5oz of oil. You can verify in the sight glass when it's covering the dot. To change, you can either siphon the oil out or remove the drain bolt on the bottom. I retightened it with slip pliers until the O-ring was snug. I confirmed with a pressure gauge that the pump is preset to ~2500PSI @ open and closed triggers @ ~3100PSI from a 190CC engine. Seems to work a bit better than the cheap vertical engine pumps but I'll update my review soon after an extensive test.