Customer Reviews for VEVOR Overhead Garage Storage Rack, 36x72 inch Garage Ceiling Storage Racks, Heavy Duty Adjustable Cold Rolled Steel Racks for Garage Storage, Organization, 550 lbs Load Capacity, 22''-40", Black

Really good quality overhead storage system, at a sensible price. All parts & packing very high quality … shame that the instructions leaflet is so poor. There’s a couple of steps along the way where they really let you down and even experienced diy nous isn’t enough to save you from the odd mid-step.

Saves floor space

Great quality product at a great price would definitely buy again

I bought this VEVOR rack because the price is way better than the big-name brands, and once it's actually up, it’s a really sturdy bit of kit. You get plenty of heavy-duty steel for your money, and the height adjustment is perfect I’ve got mine dropped about 600mm, which clears out heaps of floor space in my tight double garage without me hitting my head. Just be warned that assembly is a bit of a challenge; there are tons of nuts and bolts and the instructions are pretty vague, so expect it to take a few hours to get it level and secure. I’d also highly recommend swapping out the included ceiling screws for some decent ones from Bunnings, as the ones in the box aren't great and tend to snap. If you’re handy with a drill and have some patience, it’s definitely a winner for the price.

These are excellent value. Have installed 3 in single car garage. They hold the weight as advertised. Make sure you use all bolts and ensure they are in a stud. Recommend.

I installed 2 of these racks in 3'x6' size (ordered together at the same time). One of them was missing portions of the template intended to conveniently measure the ceiling mount points. Luckily the other unit had the full template. After messing around with the template and measurements on the 1st one I did not use the template on the 2nd one - just measured, marked, and installed. The main M8 bolts that are holding this, and any weight loaded on it ,to the hanging brackets are low-rated 4.8 grade bolts. I upgraded these to 8.8 grade bolts for significantly increased fastener strength. I did use the locking nuts than came in the kit. To note that the provided M8 4.8 bolts were 13mm hex while the nuts were 12mm hex. The higher rated M8 8.8 bolts I bought were 12mm (so 1 less wrench to juggle). The M6 bolts used to join the 2 long side beams together are 8.8 rated, so those were ok. At least these ones were 10mm wrench/socket for both the bolts and nuts. To note I did use some thread-lock on the threads for these bolts during assembly. The nuts for these are not locnuts - they are only friction-locking. The lag screws provided for supporting the horizontal support bars are terribly cheap. I tossed those also and instead used some quality structural screws for the support fastening into my ceiling beams. To note that the support lags come with optional use plastic anchors. Of course this unit must not be installed to hang from only drywall using anchors. These anchors are perhaps intended for possible concrete ceiling drill/anchoring of the lags. In that case I would not use them either. I would use proper metal expansion anchors and rated fasteners for hanging this from concrete if that is the intent. The ends of the support sides that the racks sit on are wedged into holes in the vertical hangers. See pics. I noted that with enough jarring it is possible for these sides to come loose - potentially allowing the unit's platform and whatever is loaded