Customer Reviews for VEVOR Motorcycle Lift, 500 kg Motorcycle Center Scissor Lift Jack with Saddle & Safety Pin, Steel Motorcycle Jack Hoist Stand for Street Bikes, Cruiser Bikes, Touring Motorcycles

I do not recall them, providing the clearance needed below the bike in their ad. This became a problem for me. The jack was about 1/2 inch taller than the clearance needed to roll it under the bike. I am using a 1 inch piece of board under the kickstand to allow for clearance of the jack. Not ideal, but it works. Sorry, tried to attach some IPhone photos and apparently they were the wrong size. Maybe they can fix that along with the clearance for the jack?

Deze is zwaar genoeg maar niet geschikt voor alle motoren. Bij een Vespa GTS ligt de motor tegen de achterwiel als je hem omhoog lift dan kantelt de Vespa naar achter. Risico op kantelen van de Vespa.

Purtroppo è stato restituito perché non funzionava bene si bloccava e poi non restava sollevato

I am not impressed with the foundation of this product. I ordered the Center lift and also the caster wheel kit. I have a 2010 road king. When I lifted this bike up for the first time in the center of the bike I noticed that when I leaned on the rear or the front of the bike it’s seesawed. The frame of my bike did not leave the lift platform the platform itself is what the movement was coming from. I tried to get customer support I had to go into a chat with this company and they said that I would get an email in 1 to 2 days. This is not satisfactory for me. I’m quite possibly going to return this lift for a refund.

Unless your motorcycle sits higher than a Harley Sportster you'll have to use another jack to get this one under it. Otherwise it's a sturdy unit and with the straps I was able to move it around. A good value for the price.

It's decent but needs larger wheels. The smallest of pebbles in a garage usually prevents the lift from turning or rolling freely with a load on it.

Nice concept but when I lift my bike it rocks back and forth pretty bad .Hard to trust it up in air

Build quality on its own is quite ok. Price vs quality is very high. Some design errors make it difficult to use though. First is the fit of the lift within the tray. There is too much room/ play on both sides of the lift within the tray causing the lift to slide in de tray itself. I solved this by putting pieces of wood on both sides to make sure the lift is snug in the tray. Second are the choices of the wheels. These are fully made out of cast iron. This makes them sturdy, but extremely difficult to roll under load on a non super flat surface. PU wheels would have been the more logical choice. Third is the lack of bearings in the wheels. Combined with the cast iron wheels, this makes it even more difficult to get the wheels rolling when the lift is loaded. (Which is the whole point of the wheeled tray right).

Pretty nice except they shorted me hardware for one of the casters.

Only thing is hard to crank up. I had to fabricate a better handle. I would give 5 stars with that. Use it to detail and maintenance. Raised my whole motorcycle off the ground enough to crank it up. I like that I can move it anywhere in the garage and push it to a corner easily.