Customer Reviews for VEVOR Liner Puller Cylinder Liner Puller, Diesel Engines Liner Puller Tool, Both Dry-Type and Wet-Type Fit Diameter of 75 mm-138 mm, Universal Cylinder Liner Puller Tool Set for Auto Repair

El producto es muy bueno , saqué los cilindros del motor sin ningún problema , para el taller es perfecto

As others have said the bearing falls apart. Also the pipe that comes with it is very thin wall so it collapsed. I used 1/2” black pipe I had laying around and cut it to length. I needed this puller for a Perkins P3 that was out of a Ford tractor. I already knew that the plate wasn’t the correct size, but I wasn’t about to spend 150$ on just a plate so I took the small one that came with this kit and very carefully ground it down to size. I ended up using a 3” pipe and air hammer to help it along. They need to just not include the thin pipe and include a better bearing.

The tool worked great after grinding a square head on the adjusting screw. I was able to put a wrench on the top to keep it from spinning while I was trying to tighten.

Used this on my Allis Chalmers I-40 to remove the cylinder liners. I had to remove some material from the pulling disc with a flappy wheel on my angle grinder to make it fit. Let's face it, if you need this tool to remove cylinder liners every day, than this is not for you. It's very cheaply built, the bearing on top is very low quality, you must grease it and crimp the bearing case to the bearings or they will fall out. Mine stayed together for removal of all 4 liners. The 2 support pipes are made of tin foil, but they work. I will probably only use this tool 1 more time in my life, and it is available for my friends to use, so they do not have to buy it. I gave this tool a good review, because it did what it was supposed to, and it did not break, "yet"! I have a pic of tool in use, but it would not let me load it?

Bearing are cheap and will fail but it pulled my farmall m sleeves out only issue washad to break sleeves as the were longer than the tool was high. I pulled sleeves until max height of tool the just broke sleeves with hammer and kept pulling.

Great tool. Did what it was made for. I would recommend it .,... ......................,............

I used this to pull the sleeves on a JD350 dozer engine, same as a perkins 3.152. It accomplished the task, but i had to use a hammer to hit the tightening handle. when trying to turn the handle by hand the shaft would just turn from the force required.

Worked well you my have to sand/grind the edges smooth to fit the cylinder walls. The price was right for a one time use.

Puller works well, with the plates to suit the different size liners the flexible head allows ease of fitting down the liner. The friction bearing to provide assistance with the puller failed as it wasn't heavy duty enough to withstand the forces pulling a very tight liner out.

Good puller for the price comes with several different types sizes to accommodate different sleeves. Will work with a 1466 international. Beats building one from scrap.