Customer Reviews for VEVOR Fluid Extractor, 6.5 Liters Capacity, Manual Hand-Operated Oil Changer Vacuum Fluid Extractor with Dipstick and Suction Hose, Oil Extractor Change Pump for Automotive Fluids Vacuum Evacuation

I have not used it yet. But it looks like it's going to work for everything I could use it for like pumping bad gas out of cars.

Works as intended. Will not work with a twist style dipstick. Other than that it works great. Use it on lawnmower oil changed.

Bought this for my Malibu. It is so low to the ground that it is difficult to change the oil. The smallest hose only went 8 inches down the dipstick. It will work for my pickup and my van but no luck with the Malibu.

So, for the money, it dose what it's supposed to do. I had no real problems as far as use goes or any complications. I wish there were more details in the directions and a good way to clear the suction hose in between one job to another. I would buy again, that's the real point right!!!

Worked great! price is hard to beat! wish the tank graduations were in (freedom units :quarts / gallons / beers) but they are in units of Soda pop (liters) but I will forive them this time.

Good product

I've used this twice. Once to remove automatic transmission fluid from the transmission. And again to pump fluid into my differential to replace the differential fluid. This makes the job super easy and works well, And much quicker than doing it by hand! However I am experiencing two different quality problems. The top that screws onto the base is warped and doesn't want to thread on properly. Causes the lid not to seal properly onto the canister. And secondly the quick release on the top is very difficult to use. The quick release on the hose works perfectly well. So it seems like maybe there's some sort of quality control issue.

This fluid extractor worked great when attached to my air compressor. The included extension was need but worked for the transmission fluid of my 2007 Durango and my 2011 Ram P/U. My only gripe, which is very irritating, is the storage cylinder had this angled line that states to Not pour out your fluids too fast and allow your fluid level to go above this line. This is great because you don’t want nasty sticky fluids to get clogged in your vacuum pump. Problem is this design! I was Nowhere Near the line as I only had 6.5L of fluid to pour out; however ATF started spewing out of both sides of the manual pump handle! There was zero reason for this. Now when I pump the manual lever, residual ATF leaks out of both sides of the pump handle.

Works great

Lo he usado 1 vez y bien, lo malo instrucciones en español no, la presion en psi, por lo demás bien