Customer Reviews for VEVOR Box and Pan Brake, 1220 mm ± 15 mm, 0-130 Degrees Sheet Metal Bending Brake, Portable Mini Metal Bender with 20 Gauge Low Carbon Steel 14 Gauge Aluminum Capacity Power Handle, for Metal Bending

This break is amazing. Works as advertised. I am thrilled. Getting much work done. Am about to replace rocker panel.

For what it is, it does the job required.

Fabrication robuste, parfait pour faire de pliages.

Très bonne plieuse. Bonne qualité

Arrived fast and well packaged. Bent up some 2.0mm Aluminium and it just managed to kind of do it, bent one of the handles and flexed the unit a bit. Piece was 600mm across so within the unit, but just not quite able to cope, it worked ok on a 250mm length. So still got it done, but I’ll be using only thinner material or shorter sections going forward.

This metal bender is great & have used it recently to make various things. It's easy to use & the bends are nice & crisp . The 910 mm brake is a great size

I bought this machine mid-summer of 2026 to make sheetmetal brackets to fit around a chimney (part of firebreak). The thing is built like a tank and it's a simple intuitive process to attach the moving bender finger and its handles. After clamping it to my bench, I was getting good results within minutes. There is nothing I found surprising -- though I do recommend checking out what it can and cannot do before planning some sort of fancy bends. For example, you can't have metal extending beyond the bending finger and there is no way to narrow the finger width to bend just part of a sheet. But if you are looking to bend a piece of sheetmetal from edge to edge, this will do the job up to the rated thickness.

Nice little brake. Fully adjustable.

well built very sturdy pretty easy use easy to fold

The overall build and usability of the bending brake is quite good. It is quite heavy and suited for the job. The edges on the base, knife and anvil are all straight and sharp. There are just a few minor craftsmanship and and quality control issues. The first is the handle on the left side does not fit. The shaft on the handle is 9.8 mm, but the hole into which it must fit is only 9.6 mm. While this is easily remedied with a 3/8" HSS drill bit, it should be necessary. The right side fits just fine. The set screw for the knife depth on the left side was almost all the way out. Again, this seems like a minor and easily remedied issue, but it is likely the reason the angle bracket holding the screw on that side is ever so slightly bent. This probably occurred in shipping, but would not have happened if the set screw had been set flush. There is also signs of rusting at this corner, which are apparent at various places on the entire tool. This was present when the tool arrive, and it has been stored in a controlled environment since then. Again, minor and easily remedied. Again, it shouldn't be necessary. And finally, the instructions specify the bending brake should be fastened to the bench with 3/8" bolts. The holes in the base are too small for that. You will need to either use a slightly smaller bolt or drill out the holes to match. None of these issues are show stoppers, and I still highly recommend the tool.