Customer Reviews for Industrial Sewing Machine Motor 750W +Needle Position Energy Saving Servo Motor

Installed on 4 diffrent industrial machines with ease. So happy I made the switch. Run great! Lots of power.

Bought this for my Consew 226R.... it makes her so much easier to Control than the old clutch motor! I’ve got two recliners that have good frames and mechanisms and cheap fake leather that is peeling all over.... so, I’m ready to reupholster them!!

Hooked and going in about an hour. No real issues in lining it all up.

Motor works great, tonnes of power and fantastic low speed control. It is a bit louder at very low speeds than I was expecting, but not intrusive and becomes almost silent as RPM increases. Easy to mount.

Was shipped quickly, installed easily and works amazing. Much more power than my older Servo. I would buy more of these for our other machines when the stock units go bad.

A few reviews have said you can replace the Hall sensor with a 5k potentiometer to control the motor speed.I tried this replacement but am having a problem. My pot wiper controls the speed in the opposite direction. That is, when I turn wiper counterclockwise, the motor speed increases. When I turn the pot wiper clockwise, the, speed decreases. This is the opposite of what I would expect. (I have tired different wiring positions with no success.) Is this situation due to motor controller originally set up to use a Hall sensor? What am I doing wrong? Thanks for any help.

The servo motor works great on my Chinese shoe patch machine!It was shipped well packaged and was easy to set up with a sewing machine pedal.

Bought and install month ago and run couple of times, so far so good. See how is goes will update with full run performance. Thanks