VEVOR Spray Paint Pressure Pot Tank, 10L/2.5gal Air Paint Pressure Pot, 1.5mm+4mm Two Nozzles Two Spray Paint Guns for Industry Home Decor Architecture Construction Automotive Painting, 60PSI Max

As described very happy

As described very happy

I watched a video of the several modifications needed to use it for making molds but this one only had one small pipe inside to cut which was easy. It’s holding pressure and doing the job great. Was better than expected.

Very well packaged. Pumped to working Pressure, left for 48 hours and no loss of Pressure. So no leaks. Paint pickup tube left on but very easy to remove, just unscrewed by hand.

This has turned out to be the best value for money item . It is invaluable to my small business. it was very easy to assemble and use, with good instructions. it is very solid and works a treat.

This is a great pressure pot, the wing nuts are large, making it easy to open and close, there are attachment points at the base so you can bolt it down, or add leveling legs. There was a internal pipe that needed to be removed, but that was easily unscrewed. Much easier to set up and use in every way than my previous pressure pot.

I bought this 30L pressure pot for resin casting. Converted very easily, after watching a You Tube tutorial. The wing nuts need to be very tight. I pressurized the pot and returned the next day to check it. It had lost only a fraction of air. Very happy with the purchase. I would definitely buy this again.

I am using this as a pressure pot for resin and silicone, and it works great out-of-the-box. After 24 hours it has lost no pressure (at 50PSI) without any modifications to the seals needed. I can highly recommend this for anyone else looking into using this for resin, but do have a couple of notes that may be useful. 1) Added a \"1/4 in. FIP Brass Tee Fitting\" from my local big box store to the intake on the underside of the lid. This diverts the incoming air to the sides instead of going straight down, potentially spraying an open-faced mold. 2) Removed the suction tube from the inside to save space. Keeping it just in case I ever actually need to use this for paint. 3) Poured ~28 ounces of silicone into the bottom to create a level surface. Being silicone it will also reduce any mess from spills and can just be pulled out if I need to use this for paint in the future. 4) I don't have a traditional air compressor due to space constraints and instead use a handheld one like the \"RIDGID 18V Cordless Portable Inflator\". It doesn't lock onto the intake fittings, but is still snug enough where it can stay on by itself (these things are really intended for refilling tires, etc.). Initially had an issue with it popping off at higher pressure, but think it was actually from the intake regulator needing to be adjusted (pulled it out, turned it, pushed it back in to \"set\" it to a higher allowed pressure). And that's about it. This tank supports up to 70PSI and I use 50 for silicone and 40 for resin so it is perfect. Sturdy, well made, well-packaged, etc.

Works well. Great value. Decent size.

Tube inside was a bit tight removed due to it being used as a preasure pot. .But with a good pair of mole grips it came off.