Customer Reviews for VEVOR Tap and Die Set, 110-Piece Include Metric Size M2 to M18, Bearing Steel Taps and Dies, Essential Threading Tool for Cutting External Internal Threads, with Complete Accessories and Storage Case

Had a die break on first use, they do not have the taper needed to get started. And a few common sizes found in automotive repair are not in the kit

Good for thread chasing but not good for thread creation / cutting. Nevertheless, good price for what they are

Comparing these to an SCA set I found the quality of the tools felt a bit lower, not a huge difference. You can tell by the size markings on individual taps and dies that they come from a range of factories which doesn't inspire confidence for quality control. The box looked good, but unfortunately it arrived damaged. Some of the pieces came loose during shipping and caused a couple of sections on the inside of the case to get cracked. Overall, not bad for the price, but they should secure the pieces better for shipping.

I wanted a tap and die set with SAR sizes. I bought this by mistake. They DON’T SELL a set with plug profile taps in SAE sizes.

Always using a tap or die. Bought because it was cheap. On opening it for the first time pieces fall right out and don't stay put. Only used once on a 1/4 20. No drill bit guide included. Good if your into cheap

I bought these and so far 4 have broken, the tap holders both get stuck and the taps aren’t held in very well, very poor quality,

I gave my ratings on this set based on receiving and viewing this set, I haven't physically used it yet, though if and when I do, I hope I can change my opinion.

Half the taps and dies Don't work due to the machining of them being very poor, m10x1.5 die doesn't even fit a m10x1.5 thread and noticed a bunch of them are juat poorly machined and don't work

A good range set for the money, if your a occasional user. The worst thing about it is the cheap plastic case. It doesn't hold the dies nor a good deal of the taps, so closing and opening is fraught with pieces flying all over the place. The tool handles are also cheap and loose their grip easily on the taps. Address those 2 shortcomings and it would score better

Does the job i needed it for