Customer Reviews for VEVOR Spray Paint Shelter, 3.0m x 2.1m x 1.8m Portable Spray Paint Tent with Built-In Floor & Mesh Screen, Foldable Pop Up Paint Booth for Furniture Large DIY Hobby Tool Painting Station

Using the spray tent inside my garage and it works well, also got one of the bigger inflatable spray booth - the "tent" is so much easier to use for smaller items

The instructions weren’t great for assembly. It can be tricky to set up if you have limited space. The stakes they sent are aluminum and bend easy even with a rubber mallet.

A little difficult to assemble but got there in the end. Don't fit all the post sections together - make 3 runs and only go as far as the elbows to feed it in the sleeve, then join up. Price was good, delivery a bit slower than predicted and a good product when you get it together. Note - its quite large!

très bien, bonne qualité et facile a monter, manque juste un peu de hauteur pour mon utilisation, autrement rien a dire sur le produit

Très pratique pour petits éléments à peindre. Le montage est un peu délicat. Bien lire la notice. La livraison à été rapide

the plastic to lay on the floor was way too narrow so plan on getting your own.

This is as advertised, a budget spray booth. I set it up by myself and this would have been easier with more detailed instructions. The best advice I have is to unfold the tent and locate the 2 sleeves running lengthwise on top of the tent- I've attached a pic to show the rods passing through the sleeves. Then assemble the 2 frame sections and feed them carefully through the sleeves until the top sections are fully within the sleeves. The frames are made of various rods which attach and detach fairly easily and there's a band running through the inside of the rods which keeps the sections in the correct order. If the rod sections detach while passing them through, you can likely reattach them while within the sleeves but be aware of the possibility of tearing the sleeves or stitching; it may be better to remove from the sleeve and start over. With the rods assembled and within the sleeves, raise one side end of the tent and insert the rod end from the front frame into the rear bottom clip hole. Then insert the rod end from the rear frame into the front bottom clip hole. Now raise the other side of the tent and repeat the frame insertion into the bottom holes. The pic shows the frame crossing from front to back and you can tie at the crossover point for more stability. I didn't bother because it's set up in the garage with no wind. Also, there are a couple of straps at the bottom back edge which I pulled back and secured with bungee cords to help prevent the tent from collapsing inward, leaving a little more depth. I also placed duct tape along the bottom of the ventilation flap to completely seal it; I don't want overspray leaking out. (velcro strips are inadequate).

Great product, the item is just as described on the product information. Fast delivery and site was easy to use. Would recommend product for any novice or beginner to use when painting or staining products.

This seemed to be the largest portable paint booth I could find and it is adequate for the job. It goes up easy enough, once you figure it out, and Its plenty big. The problem is the rear vent. There is nothing to secure the fan to the tent so even though you can roll up the flap the back of the tent can easily cover half the fan and there are big gaps at the sides where overspray can escape. If you don't need the vent then it's great and even if you do a little thought can make it workable.

C’est pratique,une notice aurait été bien venu .J’ai regardé sur le site de VEVOR les images m’ont aidé au montage. Correct pour le prix.