Customer Reviews for VEVOR Single Horn Anvil, 10kg Cast Steel Anvil, High Hardness Rugged Round Horn Anvil Blacksmith, Large Countertop and Stable Base, with Round and Square Hole, Metalsmith Tool for Bending and Shaping

Bonne enclume mais le trou pour mettre les outils n'est pas de taille standard (trop grand)

When I drop a 1.25 inch ball bearing on it I get about a 90 percent rebound, and a nice ring! and I haven't put any dents in it yet. the horn is just the cast finish so its kinda ruff

This anvil does what an anvil needs to do in that it is a heavy block of metal to work hot steel on, and it's very reasonably priced. It has some shortcomings, however: 1) the horn is way too fat to be truly useful for fine blacksmithing; 2) the open belly sacrifices mass that would make the anvil much more solid if that void were filled; 3) the casting is poor, leaving the body with holes and porosity that gets covered with plastic body filler; and 4) the Pritchel (or punch) hole (the round hole) is in a completely useless position, and it is way too big. Instead of drilling it one-inch in diameter in the horn, drill it 1/2" to 9/16" in the heel, between the Hardy (square) hole and the end of the heel.

+hohe Härte +plane Fläche +keine zu scharfen Kanten +reflektiert großen Teil der Energie -keine Löcher zur Verschraubung auf einer stabileren Basis, was bei dem geringen Gewicht sehr notwendig ist -> habe zwei Spanngurte überkreuzt benutzt -Arbeitsfläche gering -> nur für kleinere Projekte -> Meiner Meinung nach zum Reinschnuppern ins Schmieden für Anfänger sehr gut geeignet

The weight and general appearance of the Anvil was very nice. Upon dressing the edges I noted some deep chips from the casting that took a bit to clean up. The Hardy hole had excessive metal I had to carefully sand out. This excessive metal was a bit above expected clean up. I’ve yet to run my hammers and steel on it but it seems solid and my bounce test was very exceptable @approximately 80% Time will tell how well it holds up but so far I am not disappointed in the general appearance

Not priced as premium quality of course, because finish is not greatly/perfectly crafted. Top Edges are not crisp/lineal as photo shows. Though surface is totally flat. Looks as though more top grinding needed done to eliminate some crumble edging appearance along top perimeter. Horn is a bit freehand ground imperfect as though quickly hand ground. Obviously the horn could be refined with a finishing disc or paper roll-gritted. Suffices for my purposes.

Good for the price, needs a little finishing but nothing serious

Anvil looks great but measurements in pics are wrong. Where it says 15in on bottom is actually only 9in

Oberfläche ist korrekt gehärtet und damit ist es ein echter kleiner Amboss.1 Punkt Abzug weil das Horn nicht richtig rund und abgeschliffen ist. kann man aber selber nachholen, wenn man es braucht.

Reçu une enclume de longeur: 34.2 cm, longueur non conforme a la description annoncée de 35.3 cm et en photo lors de la réception du colis reçu éventré, sinon bon rapport qualité prix.