Customer Reviews for VEVOR Rivet Nut Tool, 387mm Rivnut Tool Kit with 13PCS Metric and SAE Mandrels, 186PCS Rivet Nuts, M3, M4, 10-24, M5, M6, 1/4-20, 8-32, 5/16-18, M8, 3/8-16, M10, M12, 1/2-13, Semi-auto Retraction

Of the 10 rivets I installed, the handle to release the tool from the rivet only worked twice, and that was only after pulling on it as hard as I could. The other times, I had to manually spin the tool to remove it. Luckily, I wasn't using it in a small space and had room to spin the whole tool. The piece of cast metal that holds the handles ended up breaking when installing the last rivnut. Currently trying to get my money back from Vevor.

Je suis en plein chantier et pressée par le temps, je dois poser une centaine d’écrous à riveter. J'en suis à 8 écrous posés et le filetage M5 a lâché. Chantier totalement à l'arrêt et impossible de trouver la pièce détachée pour la remplacer au plus vite et espérer finir le chantier à temps.

Junk. The #10 mandrel broke the very first time I used it.

Well built tool but the mandrels seems to be not tempered properly. I ordered the rivnut tool for a small boat customization project. I broke the 1/4-20 mandrel after setting 5 rivnuts on the first use. Oops! I contacted Vevor about replacement parts and they sent me a new compete Rivnut tool kit. Well outstanding! I set about the last 18 or so 1/4-20 rivnuts making extra sure that everything lined up square as possible. That worked pretty darn good until the very last rivnut of the whole project. The location was in a bit of a awkward position and I could not completely square over the location, as soon as the rivnut started to seat, the 1/4-20 mandrel broke again. Once again I contacted Vevor and once again no parts. They offered me another complete tool set or a refund of $24.. I took the money mostly because I really don't need a 3rd set of rivnut tools with defective and non-placeable parts floating around. Really is too bad, their customer service is pretty good

l'outil est deja endommagé

Ved ikke hvordan den virker Jeg har ikke modtaget den 🤷‍♂️🤷‍♂️

Not as heavy duty as advertised. It's a hobbyist piece for lighter work. This is a better tool in the pic

I purchased the 16” semi automatic tool because I have a big project to work on. Unfortunately The slide in the tool is made out of very cheap metal and after the first couple of nut zerts installed it became very difficult to reset the tool for the next use. I would not recommend this tool only because of the internal slide is junk unfortunately because the rest of the tool works phenomenally! I don’t know if vervor will accept a return because i have used it, this is the first thing i bought from vevor that i have been disappointed by. In the photo the cork screw looking piece in the middle is the part that is bad

Never received apparently it was shipped back to the warehouse, but no notification or credit issued until I reached out.

Lower handle is way too close to what you’re working on when the rivet nut is fully seated. The nose needs to be longer if you’re going to get at it from a 90 degree angle.