Customer Reviews for VEVOR Portable Sawmill 35.6cm-91.4cm Guide Bar Galvanized Steel Chainsaw Planking 0.5cm-30cm Thickness, Wood Lumber Cross Cutting Saw Mill for Builders and Woodworkers, Silver

terribly built

Do not buy, I purchased this item and never received it. When i contacted vevor they said it takes up to 15 days to receive your refund. It's been over a month now and still no sawmill and no money. I would not purchase again.

Die Anleitung ist nur auf Englisch und im Video werden im Vergleich zur beiliegenden Anleitung Sachen anders montiert. Kommt komplett in Einzelteilen an.

Hyffsat stark men delvis svårstartad och drar endel bränsle

J'ai dû faire des modifs pour que ça fonctionne correctement et la visserie est moyenne

Mill is as advertised. I rough cut some dry cherry and it did what it was supposed to. I have a sthil 391 with a 20 in bar. Plenty of extra room for a bigger bar. Only complaint is that the bolts to secure it to your saw are tough to get to. I had to use a wobble socket to loosen and tighten.

Etwas vor ein Jahr gekauft, und nun ist der U-Bolzen gebrochen. Ansonsten bis zum Ereignis, top zufrieden.

It works pretty good BUT 1 - get yourself a pack of M8 lock washers - at least 12 2 - get a piece of silicone mat (the red stuff 1/16”) that you can put where metal meets bar. The only thing that DOESN’T WORK is the round bar. The provided screws strip out well before they are able to tighten enough to keep it from sliding. Unless this component is supposed to slide for some reason, it’s completely useless without being jury-rigged.

Be prepared to reinforce the tubes that clamp to your chainsaw bar. If you don't, and you tighten them enough to actually hold the mill together in use, you will bend the tubes and render the entire tool pretty useless in minutes. I pressed aluminum bar stock into the ends of all 4 clamp tubes and drilled clearance holes through for the bolts...and thing shave worked just fine through many dozens of oak slabs. The whole thing should have been built with beefier tubing, like the granberg stuff they tried to copy..... If you aren't handy enough or don't have time to reinforce this thing then you're just wasting your money. But if you can tune it up it will get you where you want to go.

Das genaue einstellen der Schnittbreite erfordert schon recht viel Zeit. DIe Skalen sind nicht wirklich zu gebrauchen. Aber es sind gerade Schnitte möglich.