Customer Reviews for VEVOR Magnetic Lifter, 100 kg/220 lbs Pulling Capacity, 2.5 Safety Factor, Neodymium & Steel, Lifting Magnet with Release, Permanent Lift Magnets, Heavy Duty Magnet for Hoist, Shop Crane, Block, Board

Works great handle screw came out pretty easy but other than that haven’t had any issues all around function works great

Works well, simple to use and very strong. Handle machining is a bit rough, purely cosmetic and doesn't affect functionality.

Works great on 1/4 or thicker 4x8 sheets. Any thinner the sheet well flex and fall. It must be placed dead center. If it's on an angle it will drop it.

Overall, a great value. One concern is that we had two magnets purchased pull tested by third party. Magnets advertise a 2.5 safety factor, which would have a breakaway point of 2200lbs. One of the units tested achieved 1900lbs, the other was 1700lbs. Not a huge concern, as they both tested well above pulling capacity, but we will monitor as they are re-tested every year. Only other concern is lack of spare parts availability. We use magnets on daily basis, so components need to be replaced periodically.

Leider rastet der Hebel/Arretierung nicht ein,hatte bisher aber noch keine Muße mich darum zu kümmern. Entweder muss ich ihn zurückschicken oder habe ich etwas falsch gemacht?

The magnet itself works fine, however, moving the handle from off to on is literally impossible without a 3 foot cheater bar. I'm 6 feet tall and 240 pounds...Big construction worker... This thing has so much spring tension on the handle that if you're not super careful and very strong it WILL break your wrist when you disengage the magnet due to the spring tension against the handle stop. I don't know if it's supposed to be so difficult to engage/disengage or not but it takes in excess of 100 pounds of force to actuate the handle back and forth to lock and unlock the magnet. Don't buy this if you're not 100% confident in your strength and ability to use a BIG cheater pipe!

Pésima conpra , no resistente ni 45 kg decepcionado

This item did not work at all and is very unsafe for anyone using it

Hab einen Kleiderständer bekommen

Om eerlijk te zijn vertrouw ik deze magneet niet. Het metaal MOET 100% PROPER zijn anders werkt het niet betrouwbaar. Ik wou ze gebruiken om metaal platen van 2 vierkante meter 10mm dik op mijn cnc te plaatsen. Nu gebruik ik de magneet om rest plaat van de cnc te halen, geen volle plaat. Bij 5mm plaat ben ik geruster qua draagkracht. 2mm werkt niet echt goed, plaat buigt teveel door waardoor de magneet faalt. Dus 600 kg kan deze volgens mij niet dragen. Jammer wel, had er meer van verwacht.