Customer Reviews for VEVOR Manual Honey Extractor, 2/4 Frames Honey Spinner Extractor, Stainless Steel Beekeeping Extraction, Honeycomb Drum Spinner with Lid, Apiary Centrifuge Equipment with Height Adjustable Stand

For a first extractor, this one is not bad at all and very easy to use. You do have to work with it quite a bit to get it stable and wind up the frames slowly to keep everything in balance, but for a first piece of equipment it did just fine.

It functions well so far but the lid does not attach and when spinning, the frames sometimes hit the lid as it's moving around unless I held it with my free hand and that was hard to do! I'm not sure if there's something missing or not. Seems like the lid should be attached on hinges. Also, there's no brake

Matériel livré très rapidement, coût intéressant. Matériel fabriqué en Chine, pas très stable lorsqu'on tourne la manivelle un peu rapidement. Une des pattes s'est cassée à la première utilisation.

The thread on the valve doesn't work

Out of control when spinning with frames. Not very stable when spinning. Price is good compared to other brands.

The honey extractor has the lowest quality of legs. The legs are so flimsy that the extractor acts like an off balance washer. I laid my body across it but it didn’t help. I am going to have to have new legs made that are sturdy. Only other complaint was one of the screws that holds the crank in place was bent. Other than those two things I wish Vevor had pointed out that the four sides were not the same side.

The purchase was not accepted and was sent back to you. Please check it and refund my payment.Thank you!

Ramka wielkopolska nie pasuje do kosza bez przerabiania konstrukcji

Bună ziua am primit comanda dar nu apare pe site-ul dumneavoastră niciunde mărimea ramei și ca atare nu este compatibilă cu ramele din România vă rog frumos să-mi spuneți ce pași trebuie să urmez deoarece doresc să o returnez Mariana Vidican

Machine is OK but the plastic ring to seal the hole for the spout is of very poor quality. Cannot fix is and seal it properly it keeps on popping. Was clearly made too short. else than that the machine works fine.