Customer Reviews for VEVOR Honey Extractor, 2 Frame Manual Honey Spinner with Transparent Lid, Stainless Steel Honeycomb Drum Spinner with Height Adjustable Stand, Honeycomb Extraction Centrifuge Equipment for Beekeeping

Works as expected

Perfect little backyard extractor for the hobbyist that doesnt want to break the bank....just anchor the legs down and make sure the frames are balanced and its good to go.

did not see anything that except for the top covers, when frames rotate around they can hit the little knobs that hold the cover in place. you can make a easy work around for this. thats the only thing I see they need to improve on.

Für den Preis eine super Schleuder für geringe Mengen

Good value for money, used once and I am happy with the result. Quality is good for price. Frame holders are slightly big but can still be used.

I liked how easy it was to put together. I would recommend bolting or screwing the legs onto a piece of plywood. If you spin it super fast with uneven frames, it will get really wobbly. We extracted about 2 1/2 gallons of honey using this and I feel it was worth the research and the money.

Good product does gets the job done but... I had to bolt it down not just on the bottom of legs because it was very wobbly even after it was secured at the legs still wobbled alot like it was off center... it's super easy to assemble it's the size is as advertised i still use it so the value was worth it to me just be aware that when you speed up the spinning it will wobble alit unless secured well

You can buy this EXACT same extractor branded different ways for twice the price. This was the first time I have ever extracted honey. The extractor was easy to use and fairly easy to clean. The spout where the honey flows out of the extractor should be a little lower as the way it is will always leave about 1/2" of honey in the bottom, I had to tilt the extractor and hold it that way for a while to get the last 1/2 inch out. I don't think you can beat this product for the $$

Works as it should

I haven't had a chance to use it yet, but I did put it together which was a snap, I beefed up the legs with flat bar, just bolted them to the existing legs and made a base with 3/4" plywood to bolt the unit to. This will stabilize the extractor when spinning the frames, some may be medium and some may be small so the balance may be off a bit when spinning a combination of different frame sizes. I also made up 2 silicon gaskets cut from a silicon pie plate from the dollar store to sandwich between the inner and outer sides of the honey drain spout. these little improvements cost nothing really and I will have no surprises when I start harvesting. It's a nice unit and since I'm retired I have plenty of time to spin 3 frames at a time as apposed to 4 with my old extractor which was too big and so hard to clean.