Customer Reviews for VEVOR Chainsaw Mill, Vertical Lumber Cutting Guide with 5.1-15.2cm Cutting Width, Cast Iron Portable Timber Chainsaw Attachment, Lightweight Wood Timber Milling Attachment for Builders and Woodworkers

Works great easy to use awesome little piece of equipment

Simple Vorrichtung zum Sägen mit Führungsschiene. Die Klemmbefestigung des Schwertes ist nicht ausgereift mit den Schrauben& Muttern. Daher die 3 Sterne bzgl. Bedienung. Für einfache Sägearbeiten und für Handwerker mit "Bastlerfähigkeiten" gut geeignet.

Die Vorrichtung macht was sie soll, ich habe aber die kleinen M6 Schrauben nebst Muttern ersetzt durch zwei zusätzliche Gewinde Bohrungen samt Madenschrauben, wie einseitig schon ab Werk vorhanden, somit konnte ich das Schwert besser einstellen

For $24 it is reasonable. I wish the screws to clamp the bar were designed differently - maybe a wider spread to reduce sliding / spread out the gripping of the bar. If you want it to hold, you will have to tighten them enough to chew up your bar face coating. If you're milling one flat surface on a log in the field (on atv) like I did, on a couple logs, works OK. Don't expect to get a ton of boards out of it, it is a tiny $24 item so I guess that makes sense.

I chose the vevor because the clamping mechanism is cast iron. It attaches securely to the guide bar with no flexing and with an old 2 x 4 I was able to slab a very straight board. I think the key is to cut lightly back and forth to get the best result. The set screws used for clamping are okay but its probably best to tighten them and then leave it rather than putting the guide on and off your saw. If the set screws mush out on me I'll just replace with some bolts instead.

It’s pretty good, I’m impressed. But there bolts and nuts on one side, and it makes no sense. Just tighten against them and it works, but I’m worried the screws will fall out and hit the chain.

Fais vraiment bien le travail, mais les boulons dois être changer pour un travail optimale !!

Works great after slight modifications, the 2 m6 pinch bolts keep rattling loose, however the Allen bolts stay put, I drilled and helicopter the 2 bolt holes and bought 2 more Allen bolts, less than $5 and 15 min off my time and its flawless.

It's very easy for a beginner to operate.

The mill part itself work pretty well, however the tool kit it came with was full of mold. The bar wrench once cleaned is very good, it's earned a spot in my tool kit.