Customer Reviews for VEVOR Bearing Puller Kit, 14-Piece 5 Ton Capacity Bearing Separator, Pinion Wheel Bearing Removal Kit with 50 mm and 70 mm Jaws, Bearing Puller Set, Heavy Duty Bearing Splitter Tool Kit with Case

Good for light use

It does the job very good, a little worn on the edges after pulling the bearing braces. I am supposed to give 5stars for the price but, a rod should be the longer one as in the picture, I didn’t need it but maybe need in the future, still thinking should I return it. E… all in all, it is still a good product for DIYers.

Bolts bend and one broke off. I have to source some grade 8 bolts from my local hardware store to use on it. Maybe fix the bolt problem and it won't be a bad tool. All this while removing carrier bearings on a 8.8 axle. So no I didn't put to much on it.

Received bearing puller kit with damaged blow molded case. Very low quality I don’t have high hopes for damage free operation.

Producto de calidad regular

I bought this item to remove a wheel bearing from the hub. The kit arrived promptly and appeared solid. However, was not up to doing the job, bolts which should pull the jaws of the bearing separator plate are too soft and bent like bananas. I had to use other means to remove the bearing. I am going to buy some high tensile bolts to try next time. But I'm not sure how tough the metal used for the separator plates is.

The user did not leave any written comments.

The push rod is very soft. The point at the end crushed at my first try to remove the bearing of an angle grinder. Then the push rod and the holding rods bent too.

Purchased this to remove bearing on my driveshaft carrier bearing. Perfect fit looked like it would make it a breeze to get bearing off. But broke on first try. Material is just too soft not hardened.

Manque des écrou et des rondelles dans le kit mes convient