Customer Reviews for VEVOR Annular Cutter Set, 13 pcs Weldon Shank Mag Drill Bits, 50.8mm Cutting Depth, 7/16" to 1-1/16" Cutting Diameter, M2AL HSS, with 2 Pilot Pins, Hex Wrench and Portable Case, for Using with Magnetic Dr

Die Bohrer funktionieren tadellos und sind Sau scharf und passen perfekt in die Magnetbohrmaschine die ich hier gekauft habe

There seems to be a lot of confusion on what annular cutters fit the quick insert mag drills. Many folks have posted negative reviews because they order the wrong type of cutters such as weldon shanks. This universal Shank Mag cutters are a perfect fit if your mag drill has the wonderful quick insert/intall mechanism. The only remaining thing I wish would be to have more imperial sizes available, such as sub 1 inch sizes.

I bought this to go with the Vevor mag drill I bought. The annular cutters are very nicely made and are razor sharp. Handled cutting about two dozen 5/8 inch holes without issue.Very good value and recommend it to anyone needing annular cutters.

So far so good, drilling holes with the best of them.

To be honest I was surprised how sharp and how well these bits cut. I would buy these again in a heartbeat.

These bits are very sharp I drilled hundreds of holes thru 1/8" steel with no problem and even drilled a few holes in 5/8" steel I Beam . Only had one but snap on me drilling when the magnet didn't seem to hold so good , so I had to clamp the drill down because I think the steel beam wasn't wide enough to hold.so I had to order two bits that broke for replacement. Other than that issue , I love this mag drilll.As long as you don't force it to fast it drills real good and use plenty of drilling lube.

Good set for the price. Dulled a little fast

Sehr Gute Werkzeug

Snelle levering keurig verpakt kan ze helaas niet uit proberen want de magneet boor machine is wegens beschadiging tijdens transport weer terug gestuurd naar afzender. Hoop dat het gauw opgelost wordt.

HAN SIDO EL COMPLEMENTO AL TALADRO MAGNETICO QUE COMPRE, CASI TAN CARAS COMO EL PROPIO TALADRO, PERO PARECE QUE VAN BIEN, CON UNA DE ELLAS HE REALIZADO UNOS TRESCIENTOS TALADROS EN ESPESOR 4 MM Y 20 EN 10 MM Y NO APRECIO NINGUNA PÉRDIDA DE RENDIMIENTO. ESTOY MUY CONTENTO CON EL CONJUNTO.