Customer Reviews for VEVOR 52 cc Gas Chainsaw, 455 mm Gas Powered Chainsaw, 1.8 kW Power Chain Saw with Non-Slip Handle, Gas-Powered Chainsaws with Dual Fuel Tanks, For Wood Cutting, Tree Trimming, and Land Clearing

Very hard to start , floods easily, doesn’t cut like a 62cc should, my 42 cc husky cuts about the same. It’s heavy. But it did the job cutting a 20 red oak tree.

This is a good saw if you are mechanically inclined and experienced with small 2 stroke engines. Two big things about this saw. 1) The pull rope does not have to be pulled hard. Let it do its work, don’t force it. Make sure to read the instructions on this. You will easily break the recoil starter and/or pull rope. 2) The saw started and ran fine for about 5 minutes, then due to the certain quality of manufacturing you get with this price range, it promptly stopped starting and ran very roughly, then not at all. I had to take the carb off and clean it after about 30 minutes of running the saw. The gas was good, but the filter screen had debris in it, and the jet was clogged. Not a big deal if you know what you’re doing, but it’s a thing that a lot of folks won’t know what to do with. I’d say this is more saw for the price than you’ll get anywhere else and it works very well when operating properly. I’d recommend a carb clean after a few hours of running, and I’d replace the bar and chain with a high quality product. Overall, good, but not great. 7/10.

Fuel tank, casing leaks fuel odors, leaving fuel / odors at unwanted places.

Purchased this saw to cut down several trees. When its running, its great! I have yet to get it to start withing 5-10 pulls. After running a tank of gas theough it or ahutting it off, it just will NOT start. I have followed the instructions for starting but no real luck. I do love it when it itll run! Hioefully someone from Vevor will see this and offer some recommendations for starting. Seems to me a primer bulb wouldve been helpful.

For the price the saw is ok. It's hard to start it pretty much all the time and it is less economical in terms of gas in comparison to other comparable size chain saws. On the good side, it's cheap and will do the job if u get it started.

For price good. Chain tensioner is a pain to adjust.

first time i used ,it worked ok , second time i bent the chain and now wont track on bar.

Came with the Gas filter just sitting in the gas tank. Once I drained the fuel, and attached the filter on the gas line it was very hard to start. It is a 2 man start. Meaning the first man will tire before it starts and it requires a second person to finish. I was able to get it running, and it worked just fine. Now comes the bad part....When I tried to start it the next day, it would not start. Garbage.

So far only one complaint and that is they don’t make replacement bars or upgrad bars. You can find bars that fit and work for it but I couldn’t find one from VEVOR . I have used it a bit safe to say I have bucked up over a cord and used it on a few other small projects. Runs great starts fine all the time. The kill switch stopped working so I just choke it to kill it.

Bar oil has leaked bad since day one.