Customer Reviews for VEVOR Rotary Welding Positioner 50KG, 0-90° Welding Positioning Turntable Table 0.5-6RPM 120W, with 12.4 Inch 3-Jaw Lathe Chuck & Welding Torch Stand Holder for Cutting, Grinding, Assembly, Testing

I got the 10kg rated positioner, that's probably an accurate estimation of it's capacity. However, it has 2 main problems. Firstly, it's almost unusable with the gear ratio provided, it spins far too fast unless you're welding pencils or something. Luckily, that's a $15 fix by purchasing a 15rpm gearmotor and throwing away the 88rpm one that comes with the unit. Secondly, the chuck is very underrated for this positioner. It's more than a $15 fix, but I had a 5" chuck from an old lathe that I was able to adapt to this, and it suits it much better. So basically, it spins too fast and the chuck is too small. But it's so inexpensive I would still buy it again if I lost this one. One more thing that would be nice is a digital readout on your rpm so you could do repeatable procedures, but not a must-have.

I dont think they could make the arm that holds the mig gun couldn't be made any cheaper its all pretty sloppy with little tiny wing nuts that dont hold the arm still they should just make better & charge a little more ,the motor part works fine so far the timer could be a little better & it could go a little slower the speed adjustment is all over the place.

Works good for the price but definitely need to move slower wanted to use to roll out tig welded stainless fittings

It arrived with a damaged box; it works, but it's dented. I need a replacement and a refund.

Grounding system is not very good, grounds through a contact piece that touches the bottom of the turning plate. Does not ground well. Would not buy again