Customer Reviews for VEVOR 22 Pieces 9.1M Dryer Vent Cleaner Kit, Include 3 Different Sizes Flexible Lint Trap Brush, Reinforced Nylon Duct Cleaning Dryer Vent Brush, Dryer Cleaning Kit with Clamp Connectors

I purchased this because of the two brush sizes. One that fit the Dryer Vent and one fitting the Heating vents. Although I already clean my dryer vent using a “Linteater” product, I was hoping the threaded connections on the rods from Linteater and Vevor would be common. (no such luck). Regardless, the Vevor kit did the job well, but it is really a two person job. You cannot just make one long connection with one person feeding the brush end into the vent and the second person running the drill end. The wriggling snake you create is really tough for even two people to handle. Anything over about 6 to 8 feet becomes too unstable and wraps itself into a twisted mess, unless it is within the duct. We ruined one of the rods in that attempt. So we now push the rods onto the vent 2 or 3 connections at a time until we reach the end. With the furnace or dryer (depending on the vent) pushing cool air plus my shop vacuum catching the dust or lint expelled, we run the drill scrubbing the vent, slowly pulling the rods on the way out, stopping to disconnect every two or three rods as they became visible. (The stability of the rod while spinning being the concern) A slower but safer process. My big negative is the threaded rods became tough to disconnect and actually needed to use a couple of pliers to help get a grip on the rods. But in all - the kit worked great – I only wondered if the set that snaps together might have been a better choice? (You could spin it in either direction – if you wanted?)

Dryer vent was never cleaned before. I used this product and it did a great job. I was amazed by the amount of lint that came out. This product was very effective and easy to use. It did a fantastic job and I was impressed by what it cleared out of the vent.

So, this does work amazingly well, very easy to use for cleaning the dryer vent, seriously the entire process of cleaning the vent took only about 10-15 minutes. The biggest complaint that I have is that if you are using the drill attachment (and you will want to use the drill attachment, trust me, it would have taken so much longer doing it without it), the rods get so tightly attached that you will need to use plyers to unthread them to disassemble. Not really that big of a deal, but if you don't have two sets of plyers available to use, you are going to find yourself stuck with, best case scenario, a long rod that is difficult to store when you are done, worst case scenario unable to add in extra pieces for a longer rod to reach all the way through the vent. Also, the instructions say to wear eye protection and a respirator, it should also advise you to wear something to cover your hair if you have a dryer vent that is above the level of your head (dryer lint is very hard to wash out of hair, learned that the hard way).