Customer Reviews for VEVOR 2.2KW Electric Motor 2800 rpm, AC 220~240V 13.8A, 90L, B3 Frame, Air Compressor Motor Single Phase, 24mm Keyed Shaft, CW/CCW Rotation for Agricultural Machinery and General Equipment

Très bon moteur pour un compresseur 100 l . Commande reçue en deux jours, super prix et bonne qualité 👍 Un bémol pour la notice qui n'est vraiment pas explicite sur le changement de rotation.

This motor works as it should, the shaft is exactly 24mm as you'd hope. I bought it to replace a dead 1.5KW on my compressor, so hopefully this one should survive a bit longer (more oomph, less strain). I can't say much about the quality, it looks identical to the other motor, just a bit bigger, but it works then so it's pretty good. Wiring diagrams in the manual are useless, fortunately there is another on the cover of the capacitor box, which is correct. I did contact Vevor about this and they were very helpful. It's installed and running, so, so far so good. I'm happy.

For the price, a good single phase 3hp motor, the rotation speed is not 3450 rpm but 2890 , good construction works very nicely aplied in a cereal cruscher. Very satisfied whith this purchase.

Prijs kwaliteit uitstekend

Fixation standard = facilité pour remplacer l'ancien moteur

Aucun souci. Manque des informations pour l'alimentation.

The motor itself appears to be of good quality sound construction, once set up, connected and running it is smooth and very low noise. I noticed that many people have concerns over the wiring diagram being a little vague and ambiguous. I have to agree that I also found this, but on further inspection I think the problem is that when comparing the schematic to the actual wiring, the schematic leaves out the thermal/overload cut out switch which provides the missing wire in the diagram as it is already installed and connected. Therefore in the counter clockwise diagram the neutral feed should go to the terminal marked U2 and the live(Line) feed gets connected to the Thermal/overload switch which is per-connected to U1, but this is not shown. In the clockwise rotation diagram it would have been helpful to identify the U2 connection as Neutral feed and the U1 as going to the thermal/overload and then to Live(Line) feed. I don’t know if all units come pre-wired for the same direction of rotation but there must be some standards in the assembly procedure, mine arrived wired for Counter clockwise which actually suited my requirements so I did not need to make any changes. To alter the rotation direction all that is needed is to change the bridged connection between Z2-U2 to be Z2-U1 then supply U1 from the thermal switch and the bridge between U1-V1 to be U2-V1. Please note I do not have any formal electrical qualifications but I do know what I’m doing, if you have any doubts/concerns then please consult a qualified electrician. I was going to give this 4 stars as the wiring diagram is vague but the product itself is good so i stick with 5 stars

Très bon article, qualité très bien, tarif très correct. Et rapidité de livraison, je l'ai reçu en 24h sans frais de port.

Au top.

J'ai acheté ce moteur électrique pour l'assemblée dans un ancien caisson de compresseur avec une tête de compresseur vevor, le tour relier sur une cuve de 500 litres, et bien ça fonctionne très bien quand la cuve est vide il faut 20 minutes pour la remplir mais comme elle n'est jamais entièrement vide l'ensemble se comporte très bien, vraiment content