Customer Reviews for VEVOR 3 Point Hitch Pallet Fork, 997.9 kg Load Capacity, Fork Attachment for Category 1 Tractor, Steel Tractor Heavy Equipment Attachment, for Tractor, Skid Steer Loader

Forks great just dont fit my bucket well because of step on bucket. Other than that no problem If bucket was flat would mount great. I just got to build something so they will clamp more securely.

These 4000 lb. pallet forks should have come with a stabilizer bar to limit side to side movement, the same as the smaller forks. Also, the screw down rods (2 each fork) would be much better with a nut welded to the plate and the rod would then screw down into the nut. As it is the nut is attached to the screw rod, and as soon as the nut reaches the plate, the whole plate slips and slides sideways. This causes paint to be removed from the plate and constant repositioning of the plate while tightening.. This would not happen if the nut were attached to the plate as the rod would hold the nut and plate in place.

They work great for the price. I wouldn't push them too hard but I have lifted over 1000# without an issue. Would buy again for the price.

Pallet forks are well constructed and very solidly made Unfortunately, had trouble mounting on our tractor bucket being impossible to secure without using a pice of plywood under the clamp both to stop it slipping when tightening The forks could really benefit from having a connector bar between the two to stop side ways movement Other than that have been quite useful but need to stop and tighten after a few uses

I bought these forks because they looked like a perfect fit for my New Holland tractor. Looked perfect when unpacking however I ran into a problem. When trying to attach my lower control arms I found the holes drilled on the bracket were too close to the frame of the fork attachment. I could not put the pin in, the holes should have been an inch farther from the frame. Not sure if I should return or remove and weld on new steel brackets that are a little longer. I willl attach the picture. I the lower arm will be beside the bracket for the picture to show distance is not large enough

I bought these back I September 2026. Do to injuries. I just opened these on November 6th. Looks great, well built. Just missing parts. I got the 4000 lb set. 2 screws per fork. I only recieved 2 bolts. I can use them with out the other screws. I don't want to damage the forks, or my bucket. Hopefully Vevor will step up and send me the missing parts.

Love these forks. I also bought the fork extensions, vevor needs a set fork the bucket forks. I modified mine. See the photo below.

attache sur les bras de relevage trop courte, attache des fourche trop fragile

Die Gabel selbst hält die 1000kg vielleicht aus aber nicht die CAT1/CAT2 Bolzen. Habe damit ca. 400kg gehoben und die Bolzen sind verbogen.

OK for price but cross member broke on first use. will have to weld on stronger box section