Customer Reviews for VEVOR Manual Tile Cutter, 1000mm, Porcelain Ceramic Tile Cutter with Tungsten Carbide Cutting Wheel, Infrared Positioning, Anti-Skid Feet, Durable Rails for professional installers or beginners

Laser même regler, est pas juste, et coupe de travers dans la longueur... produit lourd...

Honnêtement je suis déçu de ce produit la coupe se fait tres très mal ou ne coupe pas. Pour le prix je ne le recommande pas désolé.

Funciona bien un par de meses, después solo podré cortar unos 50 cm. , pienso que estructura bastante floja y dobla

Generalnie tnie, ale wygina sie jak szalony. Nawet przy krótkich plytkach, zeby uciac równo, wypadałoby odkręcić, bo przy tych 30cm jest na tyle miękko i brak oparcia dla prowadnicy ze ostrze nie ma jak rysować, dopiero od 15cm zaczyna ciąć.

J’ai fait un travail avec cette scie a carreaux et je ne suis pas satisfait , le rail supérieur ou le couteau glisse n’est pas assez rigide , par conséquent , les grands carreaux sont plus problématique.

Para cortar azulejos pequeños supongo que sirve. Los de 120 no los corta bien.

I bought the 47 inch tile cutter about 2 months ago and have done one project with it. I found the laser light useful particularly as the built in square on the tool was not square. The roller cutter was smooth and cut cleanly. There was flex in the base so one had to ensure it was on a solid table. I would not recommend this tile cutter for extended use as it required more measuring because of the out of square guide.

This was of some use for a while but it doesn’t cut accurately and the rails are weak and flex, look, you get what you pay for but I wouldn’t buy another one and ended up spending much more money on a descent tile cutter

I bought this to cut large format tiles, 24 x 48. I have several smaller cutters. The trend to larger tile sizes forced me to get a new bigger one. The packaging looks good on the outside. However when I set it up and started using it I quickly realized it was going to be a challenge to get the job done correctly. One of the biggest gripes I have is they didn't calibrate the tool. There maybe a laser mounted on the head but as is out of the box it's useless. You will need to adjust it. Then I put a tile in and scored it, pressing the snap bar separated the two halves. pull it out from the bed and how off square could it be? Try 1/8" per foot. That is ridiculous. The rails seem too thin for the length that they are. The car slides nicely. There are these wings on the sides to support tile overhang. They are flimsy are get in the way if you're not using them. The unit is put together with nylock bolts and screws. Put aside 3 hours to setup and calibrate. It's not ready to use as is out of the box. Would look elsewhere for a more robust accurate tool.

No me gustó