Customer Reviews for 15 Ton Hydraulic Gear/Bearing/Wheel Bearing Puller Separator 2 or 3 Jaws w/ Case

Oh man I’m really excited about this tool and all of the useful things It will do that was previously a struggle !!!

I used this to remove timing gears off of a 1926 Fordson Tractor engine. I had tried a conventional puller (two jaw) and used heat, penetrating oil, brass hammer, etc. Nothing worked. Once I had this puller assembled and set up, the gears were removed in less than two minutes. I like that the jaws are reversible with hooked and square cut ends as well as the adjustment collar is designed to use two or all three jaws; this is very versitle, especially when space is limited on what you are working on. It is priced right for the home shop, hobby mechanic, etc. I don't know how often I'll use something like this tool, but, it saved me on one job and I am quite satisfied.

I do not write many reviews. I wish to report that I was concerned about quality when I ordered this item but, upon arrival, was pleasantly surprised by the high gauge of the puller tongs and supporting hardware. This device had no problem pulling the rear hubs from the splines on my Miata where a smaller puller had failed. The instructions are dismal -- written in poorly-translated English -- but its assembly and use is straightforward.

Worked well for what I was using it for. I put a lot of pressure on it everything held together. Happy with the product used it on two difficult projects with no issues.JJ

This tool worked for helping me to remove a stump jumper on a brush hog.

Could not get a bearing off with all of my pullers,tried heat everything. This worked easy to remove it. Great puller

Very handy tool, I am glad I bought it.

I bought this to pull the front rotors off my Chevy van. It worked great!

Nice puller made the job easier. The bearing came right off no problem. The job normally takes a couple of hours only took 45 minutes.

I used this to remove an axle that was seized into the hub of a 2009 Honda Accord. It worked,....just barely. I was also able to use it to remove/install the front wheel bearings. The unit is well built, but heavy and unwieldy. It also comes with a very nice carrying case.