As others have said the bearing falls apart. Also the pipe that comes with it is very thin wall so it collapsed. I used 1/2” black pipe I had laying around and cut it to length. I needed this puller for a Perkins P3 that was out of a Ford tractor. I already knew that the plate wasn’t the correct size, but I wasn’t about to spend 150$ on just a plate so I took the small one that came with this kit and very carefully ground it down to size. I ended up using a 3” pipe and air hammer to help it along. They need to just not include the thin pipe and include a better bearing.

I was skeptical of this puller, because of the price. But it worked flawlessly pulling sleeves from a diesel engine, I would definitely recommend this product.

The tool worked great after grinding a square head on the adjusting screw. I was able to put a wrench on the top to keep it from spinning while I was trying to tighten.

With the knuckle in the main pull rod. I was able to do everything from the top of the motor. Sweat very nice.

Producto de excelente calidad, es tal cual como se presenta en la imagen, cumple con su función, empaque y tiempo de entrega es excelente

Great tool works fine.................................................................................

Bearing are cheap and will fail but it pulled my farmall m sleeves out only issue washad to break sleeves as the were longer than the tool was high. I pulled sleeves until max height of tool the just broke sleeves with hammer and kept pulling.

Worked perfectly on the sleeves I was pulling. Lube the provided bearing and go to work

I used this to pull the sleeves on a JD350 dozer engine, same as a perkins 3.152. It accomplished the task, but i had to use a hammer to hit the tightening handle. when trying to turn the handle by hand the shaft would just turn from the force required.

The puller works well and suits many jobs