Customer Reviews for Plasma CutterAir Plasma Cutter Non-touch Pilot Arc Cut-40 Dual Voltage 220V 40A

This plasma cutter is working way better than expected, it's actually well built and does a great job at what it's advertised to do. Highly recommend for anyone looking for a plasma cutter to cut no more than 1/2 steel.

Took a bit to get it to functional status on 120v. Haven’t had the chance fo 240v. Does what it should. Don’t really need to cut more than 3/16” an occasional 1/4”. The regulator has a leak which will get a repair or replacement. From 20 gauge sheet metal to 3/16” mild steel it hasn’t got a problem on 120v, 1/4” not so much.

This is a great device. The instructions are a bit light but its easy to figure out how to set it up and it works better than I expected. I have only used it on 220 volts so I can't comment on how well it will handle 110.

It works as they said, used it to gouge my loader bucket cracks so i could reweld it , worked very well with minim warp age. didn't try the 110 volts, I hooked it to 220 right away. would be nice to have more consumables, and a better book to go with it.

works great easy to set up has everything you need to start cutting

I works great

It worked well,I was quite surprised and satisfied with its performance

Easy to assemble. Decent product. Works fine on 110 volts, but hook that sucker up to 220 and it cuts 1/2 inch steel plate with ease!!

Clean cuts 1/8” hr steel no problem, really impressive machine for the money. Anything over 3/16 thick will work it and require some cleanup. I run it on 220v and 60psi. Definitely would buy again

Easy to use. The best I've used.