Box and Styrofoam didn't protect the contents. If it weren't so heavily made, I'm sure it wouldn't have made it. A few of the plastic pieces didn't survive, but can be easily fixed. Instructions for assembly aren't friendly, but all in all I would buy again
The instructions need to be translated into understandable English. The motor seems to get quite hot after a short period of use. Too hot to keep your hand on the housing. The cap screw that adjusts the indexing pin need to be operated by a spanner and not an allen key. You have great difficulty lining up and inserting the allen key into the top of the cap screw. A bolt with a hexagonal head would be much more user friendly. The angle zeroing marks were not placed in the correct position. The preservative coating on the cast iron slide and arm was quite difficult to remove. The finish of the machining on the cast iron slide and arm was somewhat rough and needed some smoothing before use.
I cant find any grinding wheel with a 1.25 arbor hole that is less than 6" in diameter to replace the sharpening disc that comes with the machine.
There is not enough space to accomodate anything wider than 5 inches
There is none on your website to support your product.
Not good!
I have seen complaints of no 5\8 bushing . FYI the outside diameter of an 8mm washer is close enough to 5/8. Two 8mm washers and a 8mm nut. Less than a dollar at a US hardware store makes a bushing.
rdmpyne 
